SQUARE & TRIANGLE WAVE GENERATOR WITH NEGATIVE FEEDBACK TRAINER
MODEL - OPO13

                  This trainer has been designed with a view to provide practical and experimental knowledge of Square & Triangle wave generator with negative feedback on SINGLE PCB. 

FEATURES

1. The schematic circuit diagram printed on P.C.B. for all terminals, switches, components and power supplies.
2. All ICs provided on sockets and possible to replace without opening the trainer board. 
3. All ICs are visible from top and the pin extensions are available around ICs with diagrams.
4. All terminals (2 mm sockets) soldered properly to avoid loose Connections

SPECIFICATIONS

The board consists of the following built-in parts :
1. +15V D.C. at 50mA, IC regulated power supply internally connected.
2. Three OP-AMP ICs 741.
3. Adequate no. of Electronic components.
4. Mains ON/OFF switch, Fuse and Jewel light.

EXPERIMENTS

1. To study Generation of Square Wave & Triangular wave using Schmitt Trigger, Integrator and Inverting Amplifier.
2. To Study Principle of positive & negative feed back.